cDAQ-9185/9189 User Manual
© National Instruments | I-3
digital input (parallel DIO modules
only), 5-7
PFI, 5-14
FREQ OUT signal, 6-38
frequency
division, 6-32
generation, 6-31
generator, 6-31
measurement, 6-11
Frequency Output signal, 6-38
G
generations
analog output data, 4-1
buffered hardware-timed
analog output, 4-2
digital output, 5-9
continuous pulse train, 6-27
digital output data, 5-9
frequency, 6-31
hardware-timed
analog output, 4-2
digital output, 5-9
pulse for ETS, 6-32
pulse train, 6-26
retriggerable single pulse, 6-26
simple pulse, 6-24
single pulse, 6-25
single pulse with start trigger, 6-25
software-timed
analog output, 4-1
digital output, 5-9
getting started
AI applications in software, 3-7
AO applications in software, 4-7
DI applications in software, 5-7
DO applications in software, 5-13
H
hardware-timed generations
analog output, 4-2
digital output, 5-9
I
implicit buffered
pulse-width measurement, 6-7
semi-period measurement, 6-10
installation, 1-4
internal source less than 40 MHz, 6-39
L
LabVIEW documentation, A-2
LabWindows/CVI documentation, A-2
LEDs, 1-28
Ethernet, 1-29
POWER, STATUS, ACTIVE, 1-29
LINK/ACT LED, 1-29
M
MAX chassis reservation, 1-14
Measurement Studio documentation, A-3
measurements
buffered two-signal
edge-separation, 6-23
choosing frequency, 6-15
frequency, 6-11
implicit buffered pulse-width, 6-7
implicit buffered semi-period, 6-10
period, 6-19
position, 6-19
pulse-width, 6-5
semi-period, 6-10
single pulse-width, 6-6
single semi-period, 6-10
single two-signal edge-separation, 6-23
two-signal edge-separation, 6-22
using quadrature encoders, 6-20
using two pulse encoders, 6-21
measuring
high frequency with two counters, 6-12
large range of frequencies using two
counters, 6-13
low frequency, 6-11
minimizing glitches on the output signal, 4-7
mounting, 1-15
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
