National Instruments cDAQ-9185 - Page 138

Index
I-4 | ni.com
N
.NET languages documentation, A-4
NI-DAQmx, documentation, A-2
O
on-demand edge counting, 6-4
output signals, minimizing glitches, 4-7
P
pause trigger, 6-3
period measurement, 6-19
PFI 0 SMB connector, 1-31
PFI filters, 5-14
ports PFI 0 SMB, 1-31
position measurement, 6-19
buffered, 6-21
power connector, 1-31
POWER LED, 1-29
prescaling, 6-38
pulse
encoders, 6-21
generation for ETS, 6-32
train generation, 6-26
continuous, 6-27
pulse-width measurement, 6-5
implicit buffered, 6-7
single, 6-6
Q
quadrature encoders, 6-20
R
reciprocal frequency measurement, 6-13
reserving the chassis in MAX, 1-14
reset button, 1-31
retriggerable single pulse generation, 6-26
S
sample clock
edge counting, 6-4
measurement, 6-21
semi-period measurement, 6-10
implicit buffered, 6-10
single, 6-10
simple pulse generation, 6-24
single
point edge counting, 6-4
pulse generation, 6-25
retriggerable, 6-26
with start trigger, 6-25
pulse-width measurement, 6-6
semi-period measurement, 6-10
two-signal edge-separation
measurement, 6-23
software-timed generations
analog output, 4-1
digital output, 5-9
start trigger, 6-3
STATUS LED, 1-29
STC3, 1-36
synchronization modes, 6-39
100 MHz source, 6-39
external source less than 40 MHz, 6-39
internal source less than 40 MHz, 6-39
T
technical support, A-4
training, A-4
trigger
arm start, 6-3
pause, 6-3
start, 6-3
troubleshooting, device connectivity, 1-14
two-signal edge-separation
measurement, 6-22
buffered, 6-23
single, 6-23
U
unpacking, 1-3
using the cDAQ chassis, 1-35
W
watchdog timer, 1-33, 4-7, 5-13, 6-32
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com