Index
© National Instruments Corporation I-3 GPIB-ENET/100 for Windows Me/98/95
verification error (figure), 3-7
verifying, 3-7
viewing or changing, 3-3
I
information to record, 2-3
installation
Add GPIB Hardware Wizard, 2-2
Ethernet cable, 2-4
getting started, 1-1
GPIB cable, 5-3
GPIB-ENET, 2-1
GPIB-ENET/100, 2-3
NI-488.2, 2-1
power cable, 2-4
verification, 5-1
IP address
acquiring automatically using DHCP, 2-6
choosing static IP address, 3-5
defined, 3-5
examples of valid and invalid IP
addresses (table), 3-6
static IP address, 6-3
IP parameters
DNS server, 3-5
gateway IP, 3-5
if assigned by network administrator, 3-5
if assigned by user, 3-6
IP address, 3-5
subnet mask, 3-5
ipconfig
using to determine network settings, 3-7
K
kit contents, 1-1
L
label
information to record, 2-3
location, 2-3
label (figure), 2-3
LEDs
description of each (table), 1-4
overview, 1-3
license
multiple-computer software license, 1-2
N
National Instruments Web support, D-1
network addresses
configuring, 4-1
network administrator
assigning IP parameters, 3-5
confirming DHCP availability, 2-5
if DHCP fails, 6-3
network configuration mode
entering, 6-3
when to use, 3-1
network settings
(figure), 4-2
changing, 3-3
configuring with DHCP, 2-6
configuring without DHCP, 3-1, 3-4
determining
in Windows 95, 3-7
in Windows Me/98, 3-7
network specifications, C-2
NI Developer Zone, D-1
NI-488.2
components, 1-5
configuration utility, 4-2
hardware support, 1-4
installing, 2-1
overview, 1-4
To Next Page
Loading...
Need help?
General
