Index
GPIB-ENET/100 for Windows Me/98/95 I-4 ni.com
troubleshooting wizard, 5-2
viewing or changing configuration, 4-1
O
optional equipment
hardware, 1-2
multiple-computer software license, 1-2
overview
features, 1-3
GPIB-ENET/100 hardware, 1-2
LEDs, 1-3
NI-488.2, 1-4
P
physical characteristics, C-1
placing unit into network configuration
mode, 6-3
power connection
(figure), 2-5
location, 2-4
power cord
installing, 2-4
types, 1-1
power requirements, C-1
power supply
connecting, 2-4
powering on your GPIB-ENET/100, 2-5
power-on self tests, 5-1
properties, 3-2
changing, 3-3
specifying IP settings (figure), 3-4
unconfigured device (figure), 3-3
PWR/RDY LED
description, 1-4
if blinking a pattern, 2-6, A-1
if flashing rapidly, 2-6, A-1, B-1
if red, 2-6
if yellow, 2-6, A-1
interpreting status messages, A-1
observing during self tests, 2-6
overview, A-1
when using CFG RESET switch, 6-4, 6-5
R
rear panel (figure), 2-4
rebooting
after Ethernet configuration, 3-5
after firmware update, 6-5
after installing NI-488.2, 2-2
refreshing list of Ethernet devices, 3-9
related documentation, xii
requirements, 1-1
resetting default network characteristics, 6-4
S
software
configuring NI-488.2, 4-1
installation, 2-1
overview, 1-4
software transfer rate (maximum), C-2
specifications
electrical characteristics, C-1
environmental characteristics, C-1
network specifications, C-2
physical characteristics, C-1
software characteristics, C-2
static IP parameters
assigning, 3-5
choosing static IP address, 3-5
using instead of DHCP, 3-8
when easier than using DNS, 6-3
status code number
recording, A-2
subnet mask
purpose, 3-5
selecting valid IP addresses for, 3-6
system integration, by National
Instruments, D-1
To Next Page
Loading...
Need help?
General
