National Instruments GPIB Series - Page 59

Index
GPIB-ENET/100 for Windows Me/98/95 I-2 ni.com
DNS
if not supported, 3-4
manually inserting hostname in DNS
table, 6-3
using with DHCP, 3-4, 6-2
DNS server, 3-5
Dynamic Host Configuration Protocol.
See DHCP
E
EDVR error conditions, B-2
electrical characteristics, C-1
environmental characteristics, C-1
error checking, B-6
error code, A-1
Ethernet address, 2-3
Ethernet connection
location, 2-4
Ethernet Device Configuration utility
accessing during normal operation, 6-3
busy device, 3-2, B-6
example (figure), 3-2
GPIB-ENET, B-6
if GPIB-ENET/100 is not listed, B-6
locating and starting, 3-1, 6-5
Refresh option, 3-3, B-6
unconfigured device, 3-2
verifying hostname, 3-7
when to use, 2-6, 3-1
Ethernet Device Firmware Update utility
using, 6-5
F
failed device
reported by PWR/RDY LED, 2-6, A-1
firmware
updating, 6-5
firmware update utility
before using, 6-5
important warning, 6-5
running, 6-6
upgrade location, 6-5
when to use, 6-5
front panel (figure), 1-3
G
gateway IP, 3-5
getting started, 1-1
Getting Started Wizard
(figure), 5-2
testing installation, 5-1
glossary, G-1
GPIB cable
connecting, 2-5, 5-3
GPIB Configuration utility
running before using NI-488.2, 4-1
GPIB connection
location, 2-4
GPIB-ENET
configuring, 2-1
installing, 2-1
using with GPIB-ENET/100, B-5
GPIB-ENET/100
installing, 2-3
properties, 3-2
H
hardware overview, 1-2
hostname
accepting DNS hostname, 3-8
changing DNS entry, 3-9
default hostname, 2-3
editing, 3-8
fixing verification error, 3-8
using to identify device, 6-3