8.2 Editing a Sample
Hardware
With Button 2 you can reach the EDIT tab to edit the recorded Sample.
1. Change the Start and End point of the Sample with Knob 1 and 2.
2. Enable Loop mode by pressing the right PAGE button to navigate to the second page
and then turn Knob 1.
3. Adjust the Start and End point of the Loop on the second page using knobs 2 and 3.
4. Since we recorded a drum loop in sync, there is no need to adjust Start and End of
the Sample or the Loop here, but we have to enable Loop as described above.
5. To focus on a specific part of the waveform, you can press and hold the NAVIGATE
button and use the knobs 5 and 6 to modify the zoom factor and the position in the
waveform.
Software
1. Click the Sampling button to open the Sampling Area.
2.
Select the EDIT tab by clicking on it.
Sampling
Editing a Sample
MASCHINE - Getting Started - 86
To Next Page
Loading...
