◦
GATE OPEN LAMP: This lamp indicates if the GATE is open. It does not show the ef
fect of the ATT (Attack) and REL (Release) times.
◦
GATE/NOTES ATT: Attack time for the GATE and NOTES signals that are used to control
the
EXCITER level and the SUM level. -20 - 0 - 20 - 40 - 60 - 80: 0.1 - 1 - 10 - 100 -
1000 - 10000 ms.
◦
GATE/NOTES REL: Release time for the GATE and NOTES signals that are used to con
trol the
EXCITER level and the SUM level. 0 - 20 - 40 - 60 - 80: 1 - 10 - 100 - 1000 -
10000 ms.
◦
NOTES EXC: Enables the gating of the EXCITER signal by NOTES. The ATT (Attack) and
REL (Release) times of the GATE section will also apply. If GATE is also enabled for the
EXCITER both signals need to be active to open the EXCITER output.
◦ NOTES REL: Enables the damping of the Modal Bank by Note-Off events. The damp
ing amount is set by the RELEASE knob in the DECAYS section. If REL by GATE is also
enabled, the signal will dampen with MIDI notes and NOTES 1-6 off or when the
Gate signal is off.
◦
NOTES ENV: Enables the triggering of the Envelope by notes.If GATE is also enabled
for the Envelope both signals need to be active to start the Envelope.
◦
NOTES SUM: Enables the gating of the Sum (output) signal by notes. The ATT (At
tack) and REL (Release) times of the GATE section will also apply. If GATE is also ena
bled for SUM both signals need to be active to open the Sum output.
◦
GATE EXC: Enables the gating of the Exciter signal by the audio-triggered GATE. The
ATT (Attack) and REL (Release) times of the GATE section apply here.If NOTES is also
enabled for the
EXCITER both signals need to be active to open the EXCITER output.
◦
GATE REL: Enables the damping of the Modal Bank by the closing of the GATE. The
damping amount is set by the RELEASE knob in the DECAYS section. If REL by NOTES is
also enabled, the signal will dampen when either the Gate signal is off or when
MIDI notes and
NOTES 1-6 are off.
◦
GATE ENV: Enables the triggering of the Envelope by the signal from the GATE detec
tor. If
NOTES is also enabled for the Envelope both signals need to be active to start
the Envelope.
Overview of the REAKTOR PRISM FX Interface
Overview of the REAKTOR PRISM FX Interface
REAKTOR PRISM - Manual - 49
To Next Page
Loading...
Need help?
General
