Navico Simrad RS100 - Scan Menu Options; All Scan Modes

AIS setup
AIS FUNCTION
NRS-2 only
SILENT MODE (ON/OFF) NRS-2 only
AIS DISPLAY (MMSI/NAME) NRS-2 only
CPA (>) NRS-2 only
TCPA (>) NRS-2 only
CONFIG VESSEL (>) NRS-2 only
Alarms
GPS ALERT (>)
WX ALERT (>) US/CAN country
modes
DSC ALARM (>)
CPA ALARM (>)
Handsets
WIRELESS HANDSET (>)
CONFIGURE HANDSET (>)
Diagnostics
GPS STATUS (>)
SYSTEM DIAGNOSTICS (>)
NMEA2000 STATUS (>)
AIS DIAGNOSTICS (>)
HANDSET STATUS (>)
Reset
SELECT REGION/COUNTRY SELECT REGION
SYSTEM RESET (YES/CANCEL)
Key:
(
) - a checkbox in the menu option.
¼ Note: If the menu option is selected, the checkbox has an X in it; if not selected, the checkbox will be
just an empty square. See example images in the “Edit my channels” on page 21.
( > ) - means further submenu options available.
Scan
This menu is used to access the Scan menu.
¼ Note: Scan menu can also be accessed by short pressing the SCAN key.
In the Scan menu, you can choose to scan all channels or selected channels available in the MY
CHANNELS list.
¼ Note: Scanning is not available if ATIS mode is turned on.
All scan
Scans all channels cyclically for activity. When a signal is received, scanning stops at that channel and the
BUSY icon appears on the screen. If the signal ceases for more than 5 seconds, the scan automatically
resumes.
• Press or to temporarily skip over (lock out) a busy channel and resume the scan. The direction
selected determines if the scan goes up or down the channel numbers (ie ‘forward’ or ‘reverse’). If it
is still busy when the scan completes a full cycle, it will stop again at this channel. Note that it is not
possible to skip over the priority channel.
• When stopped on a busy channel, press OK to permanently skip over the channel. The SKIP icon will
show on the LCD for this channel.
• To cancel a skipped channel, select the channel while in normal mode (non-scan mode) then press the
OK key - the SKIP icon will disappear. Repowering the radio also restores all skipped channels.
• Press SCAN or X while scanning is active to stop at the current channel and return to normal operation.
All channels + 16
Scans all channels cyclically, but checks the priority channel after every channel step.
My channels
Scans all channels selected in EDIT MY CHANNELS.
20 |
Radio menus | RS100 / RS100-B / V100 / V100-B User Manual