Navico Simrad RS100 - First Time Startup Configuration; Country and MMSI Setup; ATIS ID, Call Sign, and GPS Source

First time startup conguration
⚠Warning: Never operate the radio without the antenna connected. This may damage the
transmitter.
The first time the radio is powered up, the user is prompted to make a series of setting selections in order
to allow the radio to perform to its full potential. Some steps must be completed; some are optional and
can be completed later.
¼ Note: Press DSC/MENU key to move the cursor 1 digit to the left; press TRI key to skip this screen and
move to the next; press X key to go back one screen.
The steps are outlined below for reference:
1 Select the country and region the radio will be operated in.
2 Enter MMSI number if known, or skip to next step. Re-enter number to confirm correct entry:
¼ Note: MMSI entry can only be done once. Changing the MMSI requires radio be returned to a Simrad/
B&G dealer.
3 If you have selected the Country mode to be EU, some EU regions require you to setup ATIS. Enter the ATIS
ID number. Re-enter number to confirm correct entry:
4 Enter vessel call sign if known, or skip to next step (maximum 7 digits):
5 Select a GPS source:
NRS-1 NRS-2
| 61
Installation | RS100 / RS100-B / V100 / V100-B User Manual