NBS Technologies Advantage M8 - Error Reset: Carriage Unit; Accessing Carriage Unit for Card Retrieval; Cooling Tipper Unit Before Carriage Access

40
Removing the card remaining in Carriage Unit
1. Turn the power OFF, and then open the Top Cover by turning the key clockwise.
2. Check where the Carriage Unit stops.
In the case when the Carriage Unit stops around the Tipper Unit, wait more than one hour until the Tipper
Unit is cooled down.
After the Tipper Unit has completely cooled down, proceed to the step 3.
Open Top Cover.
Turn this key clockwise.
Tipper Unit
If the Carriage Unit stops at the
upper right position, wait until
the Tipper unit is cooled down.