Need help?Do you have a question about the NBS Technologies Advantage M8 and is the answer not in the manual?
General| Resolution | 300 dpi |
|---|---|
| Maximum Print Width | 3.37" (85.6 mm) |
| Card Capacity | 100 cards |
| Connectivity | USB |
| Encoding Options | Magnetic stripe encoding; Contact chip encoding; Contactless chip encoding |
| Supported Media Types | PVC |
| Card Thickness | 0.020" - 0.040" (0.508 mm - 1.016 mm) |
| Media Thickness | 0.020" - 0.040" (0.508 mm - 1.016 mm) |
Avoid overloading outlets, use proper cords, and check plugs for dust to prevent shock or fire.
Caution regarding the hot Tipper Unit; allow it to cool before touching to prevent burns.
How the issuing operation starts and where issued cards are stored or ejected.
Procedure for installing a new thermal transfer ribbon and removing slack.
Warning about the hot Tipper Unit and how to avoid burns.
Lists error codes and their details when the machine is in standby.
Lists error codes for consumables like film and cards not set or run out.
Lists error codes for malfunctions during operation or initialization.
Errors related to card jamming, pusher motor, and home detection.
Errors related to carrier, open covers, sequence, and parameters.
Errors related to emboss, feed, rotation, and temperature issues.
Errors related to card jams, eject, input timeouts, and missing cards.
Warning to shut down power before checking serious errors, especially for the Tipper Unit.
Errors related to the thermal print head and its module.
Errors related to card jamming and ribbon encoder issues.
Errors related to card interaction with the flipper mechanism.
Steps to remove a card jammed in the input hopper.
Alternative method to remove a card if it cannot be pulled from the rear.
Steps to open the needle lever and manually pull out the card.
Steps to pull out the card from the left side of the unit.
How to remove a card from the right side of the unit.
Instructions to wait for the Tipper Unit to cool if the carriage stops near it.
Steps to open the needle lever and remove the card from the Carriage Unit.
Reiterates caution about the hot Tipper Unit and waiting time.
How to use a screwdriver to turn the crankshaft and remove the card.
How to manually pull out a card if it was not ejected from the slot.
Steps to clean the thermal print head using a cleaning pen.
How to detach the cleaning roller and wash it with water.
How to clean drive and passive rollers on the Main Transfer Unit.
How to clean drive and passive rollers on the Vertical Rotation Unit.
To Next Page
