NComputing L-Series User Manual rev.05.07.12
Page 14 of 95
proceeding normally. If the installer takes longer than 15 minutes to complete, please contact
NComputing technical support for assistance.
• At the "vSpace Server successfully installed" screen, click “Close” to end the installer, and select
whether or not to immediately restart the computer (a restart is required before vSpace Server
can be used).
• Proceed to the following sections to connect your L-series devices, register and activate the
software and devices and update the device firmware (as needed).
User Account Creation
The L300 can access a Windows session using either local or domain user accounts. The optimal type of
user account will vary depending on the type of environment the vSpace host is being deployed into.
You can use existing accounts or, if preferred, create new user accounts specifically for the terminals.
To create new local user accounts and add them to the Remote Desktop Users Group:
1. From the host Windows session, click “Start” then Right Click on “Computer” and click “Manage”
from the dropdown menu.
2. From within the Server Manager menu select “Configuration” then “Local Users and Groups” in
the left navigation tree.
3. Right Click on “Users” and select “New User…” to create as many new users as needed.
4. Select “Groups” from the left navigation tree and double click on “Remote Desktop Users”. Click
“Add” and then enter either the user names you’ve recently created, or simply enter
“everyone”.
If you are installing a host into a domain environment which uses domain user accounts, contact your
local system or network administrator to have them create any additional user accounts that you may
need.
To Next Page
Loading...
Need help?
General
