NComputing L230 User Manual

NComputing L-Series User Manual rev.05.07.12
Page 28 of 95
L300 Device Setup
The L300 must be connected to the host PC via an Ethernet switch, router, or other network
connection. The L300 has USB ports dedicated for mice and keyboards, as indicated by the
mouse and keyboard symbols below the horizontally oriented USB ports. The vertically oriented
USB ports to the left of the audio connections are for other USB devices.
Network connection
The L300 device can be configured to use DHCP-assigned network settings, or use static IP settings
specified by the user. To use DHCP-assigned settings, power on the device, then go into the Device
Setup, click the “Network” tab, and select the bullet labeled “DHCP.”
NOTE: The USB keyboard and mouse ports ONLY support these types of devices. No other types of USB devices
are supported on these ports. The USB keyboard and USB mouse must be directly connected to these ports and
cannot go through a separate USB hub. Peripherals with integrated USB hubs or combination keyboard/mouse
devices are not supported by these ports. Other USB peripherals can be connected to the vertically oriented ports
that are to the left of the audio ports – note that these generic ports are not active until you have connected to a

NComputing L230 Specifications

General

Brand	NComputing
Model	L230
Category	Wireless Access Point
Language	English