NComputing L230 User Manual

NComputing L-Series User Manual rev.05.07.12
Page 32 of 95
The "Close" button closes the options menu.
The “Setup” Menu
Within the “Options” screen, the "Setup" button brings up a set of tabs for viewing and changing
the access device settings. Note that this is an optional step to be used for more control of the
device.
The "Save" button saves all the changes made in the tabs and closes the window. This brings
the user back to the host computer list.
The "Cancel" button discards all the changes made in the tabs and closes the window. This
brings the user back to the host computer list.
The “Network” Tab
The "Network" tab contains settings for network connectivity.
If you plan to use a static IP configuration, click on the "Use Static IP Address" radio button to
set an IP address and gateway address for the access device to use.
Otherwise, click on the "Get Dynamic IP Address" radio button to configure the access device to
use DHCP to get its IP address. Note, the MAC address is shown here for reference only and
cannot be edited.

NComputing L230 Specifications

General

Brand	NComputing
Model	L230
Category	Wireless Access Point
Language	English