NCR RealPOS 5953 - Page 33

Chapter 3: Hardware Installation 3-9
8. ConnectthecablestotheDynaKey.
• ConnecttheterminalDVIcabletotheDynaKeyDVIconnector.
• ConnectexternalUSBdevicestotheDynaKeyUSBconnectors
(optional).
• ConnecttheterminalPoweredUSBcabletotheDynaKey
PoweredUSBconnector.
Note: AsanoptiontheDynaKeycanbepower
froman
externalpowerbrick.
9. Routethecable(s)throughtheupperhalfoftheCheckstandBase
andinstalltheThumbscrewandtheFrontCover.Besuretoleave
enoughslackinthecable(s)topermiteasytiltingofthe
DynaKey.
10. Routethecable(s)intothelowerhalfof
theCheckstandBaseand
throughthecountertop.
11. SlidetheSideCoverontothelowerhalfoftheCheckstandBase.
12. SlidetheupperhalfoftheCheckstandBaseintothelowerhalfof
theCheckstandBaseandtightentheThumbscrew.