NCR RealPOS 5953 - 12.1-Inch USB DynaKey Video Drivers

4-16 Chapter 4: Programming
Command‐lineparametersmayincludeavaluefortheruntime
duration.Ifspecified,theapplicationremainsresidentonlyforthe
requestedduration.Thispermitstheapplicationtobeusedonly
duringdefinedeventssuchassystemstart‐up,andafterwhichthe
applicationwillnolongerremainresidentinmemory.
Thecommand‐
lineparametersmayalsospecifythatabackgroundmemory‐resident
instanceoftheapplicationshouldbeterminated.Inthiscase,the
applicationonlyterminatesthebackgroundinstance,anddoesnot
remainresidentitselforinvokethecontroltosetkeyclickparameters.
SetUsbKeyClickmaybelaunched“byhand”usingthe
WindowsStart>
Runoption,oranyequivalentshortcuttechnique(desktop,quick‐
launchpad,menu).Ifstartedinthismanner,thecommandlinecan
optionallycontainstringsoftheform“keyword{=value}”,where
keywordisoneofthedefinedparameters,andvalueisanoptional
numericvaluetobeapplied
tothatkey.
Thefollowingtablegivestheavailablecommand‐lineparameters.
Command-line Parameters
Keyword
1
Value (Decimal numbers) Value
close Closeanybackgroundsessionfound n/a
runtime Anumberofsecondstoremainresident,
waitingforadditionaldevicestoinitialize.
0=indefinitely
1
Keywordsarenotcasesensitive,andmaybeabbreviatedto3ormore
characters.
12.1-Inch USB DynaKey Video Drivers
Whenusing12.1displaysoranyotherdisplaysdrivenofftheC&T
69000chipset,itisrecommendedthatthevideodriversforthe69000be
used.ThesedriversareavailableonNCRsoftwareCDD370‐1111‐0100
(previously,G370‐0830‐0000).Driversandinstallationinstructionsare
availableonthissoftwareCD
forWin.3.1,Windows95,WindowsNT
4.0andWindows2000.DriversarenotneededforDOS.