NCR RealPOS 5953 - Replacing the Keylock Assembly; Re-Assembling the DynaKey

Chapter 6: Hardware Service 6-19
24. RemovetheKeylockbypryingtheRetainingClipoffwithasmall
screwdriver.
25. TheLEDBoardcanberemovedbypryingofftheTinnermanClip.
19925
Keylock Retaining Clip
Tinnerman Clip

Replacing the Keylock assembly
1. Alignthetabsandsnapintoplace.
2. Carefullyroutethewiresthroughthebezel.
Re-Assembling the DynaKey
Tore‐assembletheDynaKeymodule,usethereverseorderofthe
previousprocedures.Inaddition,checkthefollowing:
1. Beforeclosingthecabinet,checktheLCDtomakesurethereareno
fingerprintsorlintparticlesonit.
2. Makesurethecablesareroutedproperlybeforeclosingthecabinet.
