NCR RealPOS 5953 - Installing Checkstand Mount (5953-K023)

Chapter 3: Hardware Installation 3-5
Installing a 5953-K023 Checkstand Mount
Note: Thecable(s)fortheUSBDynaKeycanberoutedthroughthe
CheckstandBase
1. LoosentheThumbscrewonthesideoftheCheckstandBaseand
thenslidetheupperhalfoftheCheckstandBaseoutofthelower
halfoftheCheckstandBase.
17321
Checkstand Base
(Upper Half)
Thumbscrew
Checkstand Base
(Lower Half)
Mounting Plate
Side Cover

2. SlidetheSideCoveroffthelowerhalfoftheCheckstandBase.
3. Inthedesiredlocationonthecountertopdrillfour6mm(0.25in.)
holesforthemountingboltsandone38mm(1.5in.)holeforthe
DynaKeycable(s).UsetheCheckstandBaseasatemplate
for
locatingtheholes.
4. BolttheCheckstandBase(LowerHalf)tothecountertop.