NCR RealPOS 5953 - Hardware Installation Procedures; Introduction to Hardware Installation

Chapter 3: Hardware Installation
Introduction
Caution: Thisdeviceshouldonlybepoweredbyapowersupply
sourcewhichmeetsSafetyExtraLowVoltage(SELV)andLPS(Limited
PowerSource)requirementsperUL1950,IEC950,andEN60950.The
powersourcemustbecertifiedbytheappropriatesafetyagencyforthe
countryofinstallation.
Caution: Usea
groundingstrapwheninstallingthisfeature.
TheDynaKeyisfullyassembledatthefactory.Thissectiondescribes:
• Serialnumberlocations
• CableConnectorAccess
• MountingOptions
• InstallingaUSBDynaKey
• InstallinganIntegratedCustomerDisplay
• PoweringUp
• ScreenSavingFeatures
Sensormatic Restriction
AvoidplacingtheDynaKeywithin12inchesofaSensormatictag
detectiondevice.