NCR RealPOS 5977 - Carriage Return; Enable;Disable Cursor; Initialize Display

6-107 NCR 5977 Graphical Display Programming
Carriage Return
Format
0D
Description
This command moves the cursor to the left end of the same line.
Enable/Disable Cursor
Format
1F 43 nn
where nn = Display cursor ON/OFF
• 00 — Cursor OFF
• 01 — Cursor ON
Default: nn = 00
Description
This command causes a flashing cursor to be used whenever the Display On state is in
force. The cursor is displayed by 1x8 dots (vertical).
Initialize Display
Format
1B 40
Description
This command returns the VFD module into its default status. All configurations made
to the VFD module returns to its default settings. Codepage turns back to CP 437 at
5x7dot pixels.