9-155 Service Support Utility
Control the Service
The configuration settings of the device are automatically activated in the background
upon terminal start–up.
Stopping the Service
To stop the service from running automatically, perform the following steps.
Note: The change of start–up type takes effect upon system reboot.
Windows
1. From the Start menu, select Control Panel→Performance and
Maintenance→ Administrative Tools→Services.
2. From the services list, select NCR5976LDServiceSupport.
3. To set the start–up type, select either of the settings:
• Manual
• Disable
4. Select Apply.
5. Select OK.
Linux
1. Open a terminal and enter chkconfig ––del NCR5976LDServiceSupport.
2. Press Enter.
To Next Page
Loading...
