Chapter 3: Hardware Installation
Introduction
The goal for installing the NCR 5977 Customer Display is for a reasonably trained
operator or store manager to fully install the terminal in less than 30 minutes.
To qualify as reasonably trained, an installer or store manager must be fluent with the
terminology and basic technology of PC hardware and software. This level of
knowledge can typically be found in an individual who has installed several PC
systems, and who routinely uses a PC for personal or business computing.
Cable Requirements
The display supports RS–232 and USB interfaces, however only one type can be
connected at a time. Cable choices are:
• RS–232 Interface (Powered)
• USB Interface (Powered)
• USB Interface (Non–Powered)
Power Supply Choices
• No Power Supply for terminal powered configurations
• Universal Input Power Supply Adapter; 90–264 VAC, 50–60 Hz
Tool Needed
#2 Phillips screw driver
To Next Page
Loading...
