Retail Platform Software 7-117
Installing the Retail Platform Software
Windows
For instructions on how to install the Retail Platform Software for Windows (RPSW),
refer to Chapter 2, “RPSW Installation” in the NCR Retail Platform Software for Windows
User Guide (B005–0000–1634).
Linux
Before you install the Retail Platform Software for Linux (RPSL), make sure to provide
the following requirements:
• Root permissions
• NCR RealPOS (SUSE Linux Enterprise for Point of Service 11 SP1) Run Time Image
01.00.00.00 or greater (kernel 2.6.32.12–0.7)
• Sun JVM 1.4.2_03–b02 or greater
• 70 MB of free disk space (Full Install)
Graphical User Interface Mode
1. Open a terminal.
2. Create a new directory by entering the command:
mkdir <destination directory>
Note: The RPSL is installed at the destination directory. In this example, the
directory is named /mnt/iso.
3. Extract the downloaded installer to the new directory by entering the command:
mount –o –loop –t iso9660 D370–0699–0100_REL.2.1.5.6.iso <destination
directory>
Note: In this example, D370–0699–0100_REL 2.1.5.6 is the downloaded version.
Other versions might be available.
4. Enter cd <destination directory>.
To Next Page
Loading...
