NCR RealPOS 5977 - Using Default Settings

9-157 Service Support Utility
Using the Default Settings
Note: This feature is supported in versions 1.1 or higher.
To use the default settings for Windows or Linux, perform either of the following steps.
Windows
1. Locate the 5976LDSettings folder in your Windows directory.
2. Open the Settings.ini file.
3. Change the value of UseDefault to True.
Note: To revert to the user–defined settings, simply set the value to False.
Linux
1. Locate the /usr/local/5976LDSettings folder in your Linux directory.
2. Open the Settings.ini file.
3. Change the value of UseDefault to True.
Note: To revert to the user–defined settings, simply set the value to False.