8-137 Software Utility
3. From the Interface section, select the port where the device is connected.
• USB—select this option if you are running a USB interface. The Com Port and
Baud Rate is grayed out and the default settings are used with this option.
• RS–232C (76/77 LD Only)—select this option if you are running an RS–232
interface. Set the correct COM Port from the dropdown list to match the COM
Port where the display is connected. The Baud Rate is set at the default 9600.
4. Select Scan. The application displays the devices currently connected to the
interface you selected. The current firmware versions of the devices are also
displayed. For Serial connection, only one device is listed.
5. From the list of devices, select the device where you want to flash the firmware.
Note: Only one device at a time can be flashed with a firmware.
6. Select Flash. The firmware flashing progress is displayed and updated at the bottom
field. A 100% Flash Progress is shown if the firmware was successfully flashed to the
device.
The following screenshot illustrates an ongoing firmware flashing.
To Next Page
Loading...
