Section 4: Optional Equipment
4-24 Section 4: Optional Equipment Aspila EX Hardware
4. If using the phono jack to connect to the recorder or audio output, plug the phono jack into the
REC connector on the ADA and then skip to Step 9. If wiring directly to the terminals inside
the adapter, remove the screw on the back of the adapter. Using a small screwdriver, push the
ribs on the sides of the adapter in and remove the cover.
Do not push the ribs in too much or they may break.
Figure 4-21: REMOVE THE SCREW FROM THE ADA ADAPTER
5. Determine which terminals should be connected. Terminals T6 and T7 are used for wiring to
a recorder. If using co-axial cable to connect to the ADA, connect the core wire to T3 and the
shielding wire to T4.
6. Run the cable to the ADA adapter through the opening near the phono jack.
Figure 4-22: RUNNING THE CABLE TO THE ADA
7. Insert the cable into the terminal. Place the cap over the terminal and push down to secure the
cable.
Figure 4-23: WIRING TO THE ADA TERMINAL
To Next Page
Loading...
