NEC DT820 - Page 55

49
1.
STEP 5: Choose Screen Saver Mode.
Select an item by one of the following operations.
• Highlight an item by using , and press ,
or OK.
•Press .
STEP 6: Choose either Disable or Enable.
Select an item by one of the following operations.
• Highlight an item by using , and press
or OK.
• Press or , and press or OK.
STEP 7: The display returns to the Screen Saver
screen. When Enable is selected, on
Step 7 Select Wait Time.
Input Wait Time to launch the screen
saver (1-999 min) and press or OK.
1
1

Back
OK
1
2
[Screen Saver]
Wait Time
Screen Saver Mode
1/1
1
2
1
2
1
2
OK
Back

1/1
[Screen Saver]
Enable
Disable
TIP
Default setting is Disable (ITY-6D-1, ITY-8LDX-1).
Default setting is Enable (ITY-8LCGX-1).
If 1 Disable is specified, an afterimage may occur on the
LCD if the terminal is used for an extended length of
time. Recommend using the 2 Enable (default) setting.
TIP
The enabled item is highlighted.
TIP
Default value is 120 min.
2
2
OK
Back
[Wait Time]
Input wait time.
BK
1
120
1-999(min)