1. Before Starting Setup
Express5800/R320e-E4, R320e-M4 Installation Guide (Linux)
10
Chapter 1 Installing Operating System
1. Before Starting Setup
This section describes overview of setup and precautions on installing an OS.
Important
OS is not installed to this machine at purchasing. The system must be set up
after purchasing. Refer to this document while the system is set up again.
The target reader of this manual is a customer who has a basic knowledge of
Linux.
1.1 Supported Linux OS
This machine is compatible with the BIOS boot mode and installation due to the minor release.
Minor release (architecture)
Boot mode
UEFI Legacy
Red Hat Enterprise Linux 7.2(x86_64)
－
: Supported : Not Supported
Note For setting of the BIOS boot mode, see "Chapter 3 (1. System BIOS)" in "Maintenance
Guide".
1.2 Overview of Setup
This document describes how to set up the system by starting up the OS standard installer from the RHEL7.2
install media and installing it. The installation parameter of RHEL7.2 is input on the interactive installation
program provided by Red Hat. After installing RHEL7.2, install application programs including the ft control
software manually. Setup by using"EXPRESSBUILDER" coming with this product is not allowed.
Important This document describes the procedure for establishing the environment
recommended by NEC. If customers customize the system, fully study the system
configuration in advance, and replace the description as required to set up the
system.
To Next Page
Loading...
