EasyManua.ls Logo

NEC Express Server Express5800 Series - Connecting Optional Device; PCI Board; Hard Disk Drive; Other

NEC Express Server Express5800 Series
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2. Setting up
Express5800/R320e-E4, R320e-M4 Installation Guide (Linux)
39
Chapter 1 Installing Operating System
2.4
Connecting Optional Device
2.4.1
PCI board
If there is an uninstalled PCI board, install it by referring to the following procedure.
- Chapter 2 (5.7 PCI Card) in "Maintenance Guide"
If the LAN board is installed, duplicate it by referring to the following procedure.
- Chapter 2 (2. Network Duplexing) in "Maintenance Guide"
If the FC board is installed, duplicate it by referring to the following procedure.
- Chapter 2 (5.7.5 (2) N8803-040 Fibre Channel 1ch Board set) in "Maintenance Guide"
2.4.2
Hard disk drive
If there is an uninstalled hard disk drive, install and duplicate it by referring to the following procedure.
- Chapter 2 (5.3 2.5-inch Hard Disk Drive) in "Maintenance Guide"
- Chapter 2 (1. Hard Disk Drive Duplexing) in "Maintenance Guide"
2.4.3
Other
If there is an unconnected USB device for backup (i.e. external/internal RDX), connect the USB cable by
referring to the manual attached to the USB device.
If LAN cable connected to Management LAN conector was removed in Chapter 1 (2.2.1 Preparation for
hardware), connect it if needed.

Table of Contents

Related product manuals