NEC Express Server Express5800 Series - Installing Bundled Software; Installing Bundled Software (See Chapter 2); 2.6.2 How to Check the Kernel and Ft Control Software Version; Enabling os Boot Monitoring Feature

2. Setting up
Express5800/R320e-E4, R320e-M4 Installation Guide (Linux)
42
Chapter 1 Installing Operating System
2.6 Installing Bundled Software
2.6.1
Installing bundled software (see Chapter 2)
Install the bundled software and configure it according to Chapter 2.
2.6.2
How to check the kernel and ft control software version
Check the kernel and ft control software version by the following command
The version of the kernel being operated :
# uname -r
The version of the ft control software being operated:
# rpm -q ft-eulas
2.7 Enabling OS Boot Monitoring Feature
Enables OS Boot Monitoring feature.
Set OS Boot Monitoring feature to
Enabled
on BIOS SETUP referring to
Chapter 1 (2.2.2 Disabling OS Boot
Monitoring Feature)
. Then, specify the timeout time for
OS Boot Monitoring Timeout
parameter appropriately.
Tips
Specify the timeout time in seconds. Default setting is 600 seconds (10 minutes).