NEC Express Server Express5800 Series - Page 51

3. Procedure for Changing the System Environment Setting
Express5800/R320e-E4, R320e-M4 Installation Guide (Linux)
51
Chapter 1 Installing Operating System
5. Execute the print sub command to check the status of the created partition.
(parted) print
Model: HGST HUC156030CSS200 (scsi)
Disk /dev/sdq: 300GB
Sector size (logical/physical): 512B/512B
Partition Table: gpt
Disk Flags:
Number Start End Size File system Name Flags
1 1049kB 17.2GB 17.2GB raid
2 17.2GB 25.8GB 8598MB raid
3 25.8GB 26.9GB 1075MB ext4 raid
4 26.9GB 27.1GB 211MB fat16 raid
5 27.1GB 61.5GB 34.4GB raid
6 61.5GB 71.5GB 10.0GB * Created partition
6. Execute the toggle sub command to set raid to Flags.
(parted) toggle
Partition number? 6 * Input the number of the created partition.
Flag to Invert? raid * Input "raid".
7. Execute the print sub command to check that raid is set to Flags.
(parted) print
Model: HGST HUC156030CSS200 (scsi)
Disk /dev/sdq: 300GB
Sector size (logical/physical): 512B/512B
Partition Table: gpt
Disk Flags:
Number Start End Size File system Name Flags
1 1049kB 17.2GB 17.2GB raid
2 17.2GB 25.8GB 8598MB raid
3 25.8GB 26.9GB 1075MB ext4 raid
4 26.9GB 27.1GB 211MB fat16 raid
5 27.1GB 61.5GB 34.4GB raid
6 61.5GB 71.5GB 10.0GB raid * raid is set.
8. Execute the quit sub command to exit parted and save the setting.
(parted) quit
9. Execute the following command to set the slot 0 of the CPU/IO 1. Create the partition with the same
size as the slot 0 of the CPU/IO module 0 (steps 3 to 8).
# parted /dev/disk/by-dpid/disk-114001
10. Execute the following command and restart the system to reflect the updated partition information to
the system.
# systemctl reboot
11. Execute the following command to create the RAID1 device.
# mdadm -C /dev/md/data -l1 -n2 -b internal /dev/disk/by-dpid/disk-1[01]4001-part6
↑
(omitted) * Specify the number of the created
partition.
Continue creating array? y * Input "y".