2-20 Configuring Linux
[Status(Raid)]]
----------------------------------------------------------------------------------
name partition label status member
md0 /boot /boot DUPLEX (1)sda1 (4)sdd1
md1 /usr /usr DUPLEX (1)sda5 (4)sdd5
md2 /home /home DUPLEX (1)sda10 (4)sdd10
md3 /var /var DUPLEX (1)sda6 (4)sdd6
md4 / / DUPLEX (1)sda8 (4)sdd8
md5 /tmp /tmp DUPLEX (1)sda9 (4)sdd9
md6 /swap DUPLEX (1)sda7 (4)sdd7
md7 extra_s1 SIMPLEX (3)sdc1 (6)sdf1
md8 extra_s5 SIMPLEX (3)sdc5 (6)sdf5
md9 extra_s6 SIMPLEX (3)sdc6 (6)sdf6
----------------------------------------------------------------------------------
Command action
1 Status(Raid)
2 Status(All Disks)
3 Repair Disk
4 New Disks
5 Remove Half Disk
6 Remove Full Disks
9 <= RETURN
The following is an example of restoring (repairing) RAID (Step 3 of this
procedure).
Command action
1 Status(Raid)
2 Status(All Disks)
3 Repair Disk
4 New Disks
5 Remove Half Disk
6 Remove Full Disks
9 <= RETURN
Command: 3
[Repair Disk]
* Which SCSI SLOT? [1-6] 3
mdctl: hot added /dev/sdc6
mdctl: hot added /dev/sdc1
mdctl: hot added /dev/sdc5
Command action
1 Status(Raid)
2 Status(All Disks)
3 Repair Disk
4 New Disks
5 Remove Half Disk
6 Remove Full Disks
9 <= RETURN
Command: 1
To Next Page
Loading...
