NEC Express5800 320La - Page 175

Problem Solving 5-21
Table 5-1. LCD Error Messages (continued)
Status Lamp
Error Message
Color State
Suspected
Module
Description Action
PCI1 +3.3vAlm 00 Amber Blink PCI module #1 3.3-V power voltage alarm (lower
limit)
Contact your service
representative.
PCI1 +3.3vAlm 02 Amber Lit PCI module #1 Fatal 3.3-V power voltage alarm
(lower limit)
PCI1 +3.3vAlm 07 Amber Blink PCI module #1 3.3-V power voltage alarm (upper
limit)
PCI1 +3.3vAlm 09 Amber Lit PCI module #1 Fatal 3.3-V power voltage alarm
(upper limit)
PCI1 +3.3vsAlm00 Amber Blink PCI module #1 3.3-V power voltage alarm (lower
limit)
PCI1 +3.3vsAlm02 Amber Lit PCI module #1 Fatal 3.3-V power voltage alarm
(lower limit)
PCI1 +3.3vsAlm07 Amber Blink PCI module #1 3.3-V power voltage alarm (upper
limit)
PCI1 +3.3vsAlm09 Amber Lit PCI module #1 Fatal 3.3-V power voltage alarm
(upper limit)
PCI1 +5vAlm 00 Amber Blink PCI module #1 5-V power voltage alarm (lower limit)
PCI1 +5vAlm 02 Amber Lit PCI module #1 Fatal 5-V power voltage alarm (lower
limit)
PCI1 +5vAlm 07 Amber Blink PCI module #1 5-V power voltage alarm (upper limit)
PCI1 +5vAlm 09 Amber Lit PCI module #1 Fatal 5-V power voltage alarm (upper
limit)
PCI1 Bus PERR 01 Green Blink PCI module #1 PCI bus parity error
PCI1 Bus SERR 01 Green Blink PCI module #1 PCI but 1-bit error Contact your service
representative.
PCI1 FAN Alm 01 Amber Blink PCI module #1 Cooling fan alarm Check if the internal fan is
clean and if the internal fan
cable is connected firmly. If
the same error message is
still displayed, contact your
service representative.
PCI1 offline Green Blink PCI module #1 The PCI module has been logically
disconnected.
Activate the ft server utility,
or remove the module and
then mount it again. If the
same error message is still
displayed, contact your
service representative.
PCI1 removed Green Blink PCI module #1 The PCI module has come off. Check the module for a
removed screw, or remove
the module and then mount it
again. If the same error
message is still displayed,
contact your service
representative.