18
(2) A protective sheet is attached to the surface of
the cover to prevent scratches. Peel off before
attaching to the holder.
(3) Insert the Directory Card into the cover and
attach it to the holder.
Attach or Remove Faceplate and DESI Printer
Sheet
Removing Faceplate and DESI Printer Sheet
Remove DESI printer sheet using the following:
(1) Use the small notch at the lower right corner of
the terminal to lift the faceplate up.
(2) Remove the faceplate.
(3) Remove the DESI Printer Sheet.
Attaching Faceplate and DESI Printer Sheet
(1) After replacing the DESI Printer Sheet on the
terminal, attach the faceplate.
(2) At each corner, press the locking pin back into
place (see the diagram above).
Connect the Headset
For DT900 series, three types of headset are available;
wired headset, EHS headset, and Bluetooth headset
(DT930 Touch Panel Model only). This procedure
explains about connecting wired headset and EHS
headset cable.
(1) Plug the modular plug of headset into the
HEADSET connector on the bottom of terminal.
(1) Plastic Cover
(2) Directory Cover
(3) Directory Card Holder
(4) Groove
Ensure the faceplate is attached securely. If it is
loose, the terminal may not operate correctly if
a key is being pressed by the faceplate.
To Next Page
Loading...
Need help?
General