NEC ML440 - Industry Canada (I.C.) Notice

Important Information 4-5
ML440 End User Guide - Revision 1
Step 4 Reorient or relocate the antenna on the receiver.
Step 5 Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate this equipment.
RF Exposure Information
This product complies with FCC radiation exposure limits under the
following conditions:
• The base must be placed to allow a minimum of 20 cm (8 inches)
between the
antenna and all persons during normal operation.
• The base must not be co-located or operated in conjunction with any
other ante
nna or transmitter.
• The handset is designed for body-worn operation and meets FCC RF
exposure guidelines w
hen used with any belt clip, carrying case, or
other accessory supplied with this product.
• All necessary accessories are included
in the packag
e; any additional
or optional accessories are not required for compliance with the
guidelines.
• Third party accessories (unless approved by the manufacturer) should
be a
v
oided as these might not comply with FCC RF exposure
guidelines.
Industry Canada (I.C.) Notice
The term IC before the radio certification number only signifies that
Industry Canada technical specifications were met. Operation is subject
to the following two conditions: (1) this device may not cause
interference, & (2) this device must accept any interference, including
interference that may cause undesired operation of the device. "Privacy
of communications may not be ensured when using this telephone".
IMPORTANT