NEC NP-PH1400U - Page 146

132
5. Using On-Screen Menu
CONTROL ID �����������������������Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID set-
ting�
NOTE:
• When[ON]isselectedfor[CONTROLID],theprojectorcannotbeoperatedbyusingtheremotecontrolthatdoesnotsupport
theCONTROLIDfunction.(Inthiscasethebuttonsontheprojectorcabinetcanbeused.)
• Yoursettingwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.
• PressingandholdingtheENTERbuttonontheprojectorcabinetfor10secondswilldisplaythemenuforcancelingtheControl
ID.
Assigning or Changing the Control ID
1. Turnontheprojector.
2. PresstheIDSETbuttonontheremotecontrol.
 TheCONTROLIDscreenwillbedisplayed.
 IftheprojectorcanbeoperatedwiththecurrentremotecontrolID,the
[ACTIVE]willbedisplayed.Iftheprojectorcannotbeoperatedwiththe
currentremotecontrolID,the[INACTIVE]willbedisplayed.Tooperate
theinactiveprojector,assignthecontrolIDusedfortheprojectorby
usingthefollowingprocedure(Step3).
3. Pressoneofnumerickeypadbuttonswhilepressingandholding
theIDSETbuttonontheremotecontrol.
 Example:
 Toassign“3”,pressthe“3”buttonontheremotecontrol.
 NoIDmeansthatalltheprojectorscanbeoperatedtogetherwitha
singleremotecontrol.Toset“NoID”,enter“000”orpresstheCLEAR
button.
TIP:TherangeofIDsisfrom1to254.
4. ReleasetheIDSETbutton.
 TheupdatedCONTROLIDscreenwillbedisplayed.
NOTE:
•TheIDscanbeclearedinafewdaysafterthebatteriesarerundownorre-
moved.
•Accidentallypressinganyoneofthebuttonsoftheremotecontrolwillclear
currentlyspeciedIDwithbatteriesremoved.