NEC NP-PH1400U - Removing the Lens

169
6. Installation and Connections
6. Place the lens shroud back onto the lens hood.
• Tightenthetwoscrewstoxthelensshroud
NOTE :
Besuretoperform[CALIBRATION]afterinstallationorreplacementof
the lens. (→ page 19, 130)
Removing the lens
Before removing the lens:
1. Turnontheprojector.(→ page 18)
2. PressandholdtheSHUTTER/HOMEPOSITIONbuttonforaminimumof2seconds.
The lens position will return to the home position. (→ page 27)
3. Turnoffthemainpowerandunplugthepowercord.
4. Waitfortheprojectortocoolsufcientlybeforeremovingthelens.
1. Remove the lens shroud.
(→ page 167)
2. Slowly turn the lens release lever clockwise until it points
upward.
3. Setthesafetylevertotheleftposition(UNLOCK).
LOCK
LOCK
LENS
4. Slowlyremovethelensfromtheprojectorbypullingit
straight out.
• Afterremovingthelens,attachthelenscaptoboththe
frontandbackofthelensforproperstorage.
5. Place the lens shroud back into the lens hood.
• Tightenthetwoscrewstoxthelensshroud.
• Iftheprojectorisstoredwithoutthelens,attachthedust
cover to the lens hood.