NEC NP-PH1400U - Performing Lens Calibration

19
2. Projecting an Image (Basic Operation)
2. Press the (POWER)buttonontheprojectorcabinet
orthePOWERONbuttonontheremotecontrol.
 ThePOWERindicatorwillturntoblueandtheprojector
willbecomereadytouse.
TIP:
• Whenthemessage“PROJECTORISLOCKED!ENTERYOUR
PASSWORD.” is displayed, it means that the [SECURITY]
feature is turned on. (→ page 46)
• When the ECO message is displayed, it means that [ON] is
selectedfor[ECOMESSAGE].(→ page 126)
 Afteryouturnonyourprojector,ensurethatthecomputer
or video source is turned on.
NOTE:Whennosignalisavailable,theNEClogo(default),blue,or
black screen will be displayed.
Performing Lens Calibration
Afterinstallationorreplacementofthelens,besuretoperform
[CALIBRATION]bypressingandholdingtheORIENTATION
buttonforatleasttwosecondsorbyholdingtheCTLbutton
andpressingtheINFO/L-CALIBbuttonontheremotecontrol
Calibrationcorrectstheadjustablezoomandfocusrange.If
calibrationisnotperformed,youmaynotbeabletogetthe
bestfocusandzoomevenifyouadjustthefocusandzoom
forthelens.
• Thefollowinglensesneedcalibration:
 NP26ZL,NP27ZL,NP28ZL,NP29ZL,NP32ZL
Standby Blinking PowerOn
Steady orange
light
Blinking blue
light
Steady blue
light
(→page232)