NEC NP-PH1400U - ❹ Selecting a Source; Selecting the Computer or Video Source

22
2. Projecting an Image (Basic Operation)
❹ Selecting a Source
Selecting the computer or video source
NOTE:Turnonthecomputerorvideosourceequipmentconnectedtotheprojector.
DetectingtheSignalAutomatically
PresstheSOURCEbuttononce.Theprojectorwillsearchfortheavailable
inputsourceanddisplayit.Theinputsourcewillchangeasfollows:
COMPUTER1→COMPUTER2→COMPUTER3→HDMI→DisplayPort
→VIDEO→S-VIDEO→VIEWER→SLOT→COMPUTER1→ ...
• WiththeSOURCEscreendisplayed,youcanpresstheSOURCE
buttonafewtimestoselecttheinputsource.
TIP: If no input signal is present, the input will be skipped.
Using the Remote Control
PressanyoneoftheCOMPUTER1,COMPUTER2,COMPUTER3,HDMI,
DisplayPort,VIDEO,S-VIDEO,VIEWER,NETWORK,orSLOTbuttons.
Selecting Default Source
Youcansetasourceasthedefaultsourcesothatitwillbedisplayed
eachtimetheprojectoristurnedon.
1. PresstheMENUbutton.
 Themenuwillbedisplayed.
2. Press the ▶buttontwicetoselect[SETUP]andpressthe▼ but-
tonortheENTERbuttontoselect[BASIC].
3. Press the ▶ buttonvetimestoselect[OPTIONS(2)].
4. Press the ▼ buttonve times to select [DEFAULT SOURCE
SELECT]andpresstheENTERbutton.
 The[DEFAULTSOURCESELECT]screenwillbedisplayed.
(→ page 136)
5. Selectasourceasthedefaultsource,andpresstheENTERbut-
ton.
6. PresstheEXITbuttonafewtimestoclosethemenu.