NEC NP-PH1400U - ❿ Storing Changes for Lens Shift, Zoom, and Focus [LENS MEMORY]; Usage Example; To Store Your Adjusted Values in [REF. LENS MEMORY]

49
3. Convenient Features
❿ Storing Changes for Lens Shift, Zoom, and Focus [LENS
MEMORY]
TheadjustedvaluescanbestoredinprojectormemorywhenusingtheLENSSHIFT,ZOOMandFOCUSbuttons
oftheprojector.Adjustedvaluescanbeappliedtothesignalyouselected.Thiswilleliminatetheneedtoadjustlens
shift,focus,andzoomatthetimeofsourceselection.Therearetwowaystosaveadjustedvaluesforlensshift,zoom,
andfocus.
Functionname Description page
REF.LENSMEMORY Adjustedvaluescommontoalltheinputsignals.
Ifnoadjustedvaluesarestoredin[LENSMEMORY],thevaluesstored
in[REF.LENSMEMORY]willbeappliedforlensadjustment.
→page130
LENSMEMORY Adjustedvaluesforeachinputsignal.
Usetheadjustedvaluesforthesignalwithadifferentaspectratioor
resolution.Theadjustedvaluescanbeappliedatthetimeofsource
selection.
→page121
NOTE:
• Thelensshift,zoom,andfocusadjustmentscanbeperformedwiththeremotecontrol.(→ page 27, 29, 30)
•TheNP25FLlensdoesnotsupporttheLensMemoryfunction.
• Besuretoperform[CALIBRATION]afterreplacementofthelens.
Usage Example
Whenyouwishtodisplayonascreenhavinga4:3aspectratioanNTSCorother4:3aspectratiosignalandan
SXGAorother5:4aspectratiosignal:
Performshift,focus,andzoomadjustmentstosettheverticalscreensizeoftheverticallytall5:4aspectratiosignal
tostandard.
Both4:3aspectratiosignalsand5:4aspectratiosignalscannowbedisplayed.
Notethatwith these shift,focus,andzoomadjustments,the 4:3 aspectratio signalwillbecome smaller onthe
screen.
Toeliminatethissizereduction,adjusttheshift,focusandzoomtotheoptimumconditionforeachofthe4:3aspect
ratiosignalandthe5:4aspectratiosignal.
Memory(storage)ofeachofthesevalueswillpermitprojectionatanoptimumconditionuponsignalswitching.
To store your adjusted values in [REF. LENS MEMORY]:
1. PresstheMENUbutton.
 Themenuwillbedisplayed.
2. Press the ▶buttontoselect[SETUP]andpresstheENTERbutton.
3. Press the ▶buttontoselect[INSTALLATION(1)].