NEC NP-PH1400U - [Options(1)]

133
5. Using On-Screen Menu
[OPTIONS(1)]
Setting Auto Adjust [AUTO ADJUST]
ThisfeaturesetstheAutoAdjustmodesothatthecomputersignalcanbeautomaticallyormanuallyadjustedfor
noiseandstability.Youcanautomaticallymakeadjustmentintwoways:[NORMAL]and[FINE].
OFF ������������������������ The computer signal will not be automatically adjusted� You can manually optimize the computer signal�
NORMAL ���������������� Default setting� The computer signal will be automatically adjusted� Normally select this option�
FINE ����������������������� Select this option if fine adjustment is needed� It takes more time to switch to the source than when [NOR-
MAL]is selected�
Selecting Fan Mode [FAN MODE]
FanModeisusedtosetthespeedoftheinternalcoolingfan.
MODE �������������������� Select three modes for fan speed: AUTO, HIGH, and HIGH ALTITUDE�
AUTO: The built-in fans automatically run at a variable speed according to the internal temperature�
HIGH: The built-in fans run at high speed
HIGH ALTITUDE: The built-in fans run at a high speed� Select this option when using the projector at altitudes
approximately 5500 feet/1600 meters or higher�
SETTING ���������������� Select one of the two options ([FLOOR], [CEILING]) according to the orientation of the projector�
NOTE:
• [VERTICALTILTUP]and[VERTICALTILTDOWN]arenotavailableonthisprojector.Evenifyouselect
[VERTICALTILTUP]or[VERTICALTILTDOWN]from[FANMODE],thesettingwillbedisabled.
• Besuretoselectthe[SETTING]optionaccordingtotheprojector’sorientation.Failuretodosomaycause
product malfunction. If installing the projector on the ceiling while keeping it in a desktop orientation,
select[FLOOR]for[SETTING].
Whenyouwishtocooldownthetemperatureinsidetheprojectorquickly,select[HIGH].