NEC NP-PH1400U - Installation and Connections

168
6. Installation and Connections
(2)Makesurethatthelensreleaseleverpointsupward(RE-
LEASE).
(3)Makesurethatthesafetyleverissettotheunlockedposi-
tion(UNLOCK)topreventthelensfromfallingout.
UNLOCK
LOCK
RELEASE
LOCK
LENS
2
3
2. Removethelenscaponthebackofthelens.
• TheNP27ZLlensisusedasanexample.
NOTE:Mountingthelenswithlenscaponitsbacktotheprojectorcan
cause malfunction.
3. Place the guide pin in the correct orientation by aligning
it with the notch on the lens hood, then insert the lens
into the projector.
Push the lens slowly until it comes to a complete stop.
Guidepin
Notch
4. Setthesafetylevertotherightposition(LOCK)tolock
the lens.
LOCK
LOCK
LENS
5. Slowly turn the lens release lever counterclockwise until
thelensreleaseleverisfacingdownward.
• Ifthelensreleaselevercannotbeturned,itmeansthat
the lens is not fully inserted.
 Turnbackthelensreleaselevertotheunlockedposition
and push the lens into the projector until it comes to a
complete stop.