NEC NP-PH1400U - ❷ Mounting the Optional Board (Sold Separately)

223
9. Appendix
❷ Mounting the Optional Board (sold separately)
CAUTION
Beforemountingorremovingtheoptionalboard,besuretoturnofftheprojector,waitforthefanstostopandturn
offthemainpowerswitch.
Toolneeded:Phillipsscrewdriver(plus-head)
TheSB-01HCboardisusedasanexample.
1. Turnoffthemainpowerswitchoftheprojector.
2. Loosenthetwoscrewsontheslotcoveroftheterminalpanel.
Remove the two screws and the slot cover.
NOTE:Keepthetwoscrewsandtheslotcover.
3. Insert the optional board into the slot.
 Makesurethattheboardisinsertedintotheslotinthecorrectorientation.
 Incorrectorientationmaycausemiscommunicationbetweentheoptionalboardandprojector.