NEC NP-PH1400U - Page 207

193
7. Maintenance
2. Remove the filter.
 Pullthetopofthelteroutwardandremovethelterbylifting
it up.
Filter
3. Install the new filter.
 Insertthelterwith“↓AIRFLOW↓”facingtheprojector.
(1)Insertthelterintheange.
(2) Fitthetopedgeofthelterintheinlet.
1
2
Flange
4. Place the filter cover back onto the projector cabinet.
(1)Inserttheguidepin(4locations)oftheprojectorintothe
notch(4locations)oftheltercover.
Notch
Guidepin
(2)Slidetheltercovertotherightandtighteneachofthe
twoknobsbyturningthemclockwise.
NOTE:
Besuretocleanbothlters(leftandfrontsides)todisplaythelter
usage hours as accurate as possible.