NEC P547UL - Page 128

6. Using the VIEWER
107
③ Set a password so that the logo will not be changed without authorization
This section explains the procedure for setting the password for the rst time.
1. Move the cursor to [LOGO PASSWORD] in the sub-menu and press the ENTER button.
The [PASSWORD SETTINGS] screen is displayed.
2. Move the cursor to [NEW PASSWORD] and press the ENTER button.
• The character input screen will be displayed. Enter the password using the ▲▼◀▶ buttons
and press the ENTER button.
• Only 1–10 alphanumeric characters are allowed to be used in the password.
• When the password is entered, it will be indicated by asterisks in the entry eld.
3. Move the cursor to [CONFIRM NEW PASSWORD] and press the ENTER button.
• Enter the same password again.
4. Move the cursor to [OK] on the password setting screen and press the ENTER button.
The [LOGO PASSWORD] will be set.
TIP:
• How to erase the set [LOGO PASSWORD]
① Move the cursor to [LOGO PASSWORD] in the sub-menu and press the ENTER button.
② Press the ENTER button in the [ENTER PASSWORD] screen.
③ Enter the password, move the cursor to [OK] and press the ENTER button.
The [PASSWORD SETTINGS] screen will be displayed.
④ Move the cursor to [NEW PASSWORD] and press the ENTER button.
• Move the cursor to [OK] without entering anything in the character input screen and press the ENTER button.
⑤ Move the cursor to [CONFIRM NEW PASSWORD] and press the ENTER button.
• Move the cursor to [OK] without entering anything in the character input screen and press the ENTER button.
⑥ Move the cursor to [OK] in the password setting screen and press the ENTER button.
The set [LOGO PASSWORD] will now be deleted.