2. Projecting an Image (Basic Operation)
34
CAUTION:
Parts of the projector may become temporarily heated if the projector is turned o with the
POWER button.
Be careful to handle the projector.
NOTE:
• While the POWER indicator is blinking blue in short cycles, the power cannot be turned o.
• You cannot turn o the power for 60 seconds immediately after turning it on and displaying an image.
• Do not unplug the power cord from the projector or from the power outlet while an image is being projected. Doing so could
deteriorate the projector’s AC IN terminal or the power plug’s contact. To turn o the AC power while an image is being projected,
use the breaker, etc.
• Do not disconnect the AC power supply to the projector within 10 seconds of making adjustment or setting changes and closing
the menu. Doing so can cause loss of adjustments and settings.
2-10. When Moving the Projector
Preparation: Make sure that the projector is turned o.
1. Unplug the power cord.
2. Disconnect any other cables.
• Remove the USB memory if it is inserted into the projector.
To Next Page
Loading...
