NEC P547UL - Turning off the Projector

2. Projecting an Image (Basic Operation)
33
2-9. Turning off the Projector
To turn o the projector:
1. First, press the (POWER) button on the
projector cabinet or the STANDBY button on
the remote control.
The conrmation message will be displayed.
• The conrmation message displayed when
the power is turned o indicates the amount
of CO
2
reduction this session (→ page 38).
2. Secondly, press the ENTER button or press
the (POWER) or the STANDBY button
again.
When the light source turns o, the power turns
o too (standby mode).
When the projector goes into the standby
mode, the POWER indicator of the unit ashes
orange. (In the state, [STANDBY MODE] is
[NORMAL].)
Power On
Steady blue light
Standby
Blinking orange light
3. Mount the lens cap.
Insert the cap’s 2 (two) hooks into the grooves
of the projector, then press at the bottom of the
lens cap. The stopper is secured to the projector.
Hook
Stopper