4. Using On-Screen Menu
78
NOTE:
• This function will not be available under the following conditions:
- when a component signal is applied to the COMPUTER IN terminal
- when a Sync on Green RGB signal or composite sync signal is applied
• To enable the [AUTO POWER ON] after changing to the sleep mode turning o the projector, wait 30 seconds and input a computer
or HDMI signal.
If a computer or HDMI signal is still present when the projector is turned o, the [AUTO POWER ON] will not work and the projector
remains in standby mode.
• Depending on the projector in use, the [AUTO POWER ON] may not work properly.
In this case, set [STANDBY MODE] to [NETWORK STANDBY].
Enabling Power Management [AUTO POWER OFF]
When this option is selected you can enable the projector to automatically turn o if there is no
signal received by any input or if no operation is performed.
TIME Set an interval between 1 and 60 minutes from when no signal is received until the unit enters
standby mode.
MODE OFF The auto POWER OFF function will not operate.
ON The unit will switch o and enter standby mode if an input signal is not received after the time set
in “Time”.
TIP:
• Auto POWER OFF can be set for each standby mode.
The factory default times set for each mode are as follows.
TIME MODE
NORMAL 60 ON
NETWORK STANDBY 15 ON
SLEEP 5 OFF
• When the remaining time reaches 3 minutes before the projector is turned o, the [THE PROJECTOR WILL TURN OFF WITHIN 3
MINUTES.] message will be displayed on the bottom of the screen.
However, if you have selected “0:01”, “0:02”, or “0:03”, when the remaining time reaches 30 seconds before the projector is turned
o, the above message will be displayed.
Selecting Default Source [DEFAULT INPUT SELECT]
You can set the projector to default to any one of its inputs each time the projector is turned on.
LAST Sets the projector to default to the previous or last active input each time the projector is turned on.
AUTO Searches for an active source in order of [HDMI1] → [HDMI2] → [COMPUTER] → [HDBaseT] →
[USB-A] → [LAN] and displays the rst found source.
HDMI1 Displays the digital source from the HDMI 1 IN terminal every time the projector is turned on.
HDMI2 Displays the digital source from the HDMI 2 IN terminal every time the projector is turned on.
COMPUTER Displays the computer signal from the COMPUTER IN terminal every time the projector is turned on.
HDBaseT Projects the signal transmitted from the terminals supported HDBaseT.
USB-A Display the [VIEWER].
LAN Displays a signal from LAN port (RJ-45) or the USB Wireless LAN Unit.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
