NEC Univerge SV 9500 - To Logout; Display Enlarged Characters

93
TO LOGOUT
STEP 1: Press the preassigned Logout Feature key
on the terminal.
STEP 2: “LOGOUT?” is displayed on the LCD of the
terminal.
STEP 3: Press the Logout Feature key again, or the
Logout soft key on the terminal. The terminal
displays the Login screen.
DISPLAY ENLARGED CHARAC-
TERS
This feature enables to display characters height as a
double height size for the terminal information on the
LCD. The indication of enlarged characters is available
for 2nd line or 3rd line on the LCD. The line displayed
as enlarged characters can be switched by using the
Line/Feature key for “Display Enlarged Characters”.
Note:
The following soft key location is an example.
Note:
The Logout key is assigned by the system
administrator.
DT830
Mic NoDist Logout >>>
7:25 AM MON 11 MAY 2015
7:25 AM MON 11 MAY 2015
Logout >>>
LOGOUT?
Cancel Back Set OK
Password
Login ID
:
:
-
Note:
The feature key of “Display Enlarged Characters”
is assigned at installation. For details, contact the
system administrator.
DT830