NEC Univerge SV 9500 - Function Key Activities; Conditions for Dt830 Series

16
1.
FUNCTION KEY ACTIVITIES
Feature + 0 = Side Tone On/Off (for handset)
Feature + 1 = Turns microphone on or off.
Feature + 2 = Adjusts handset receiver volume.
Feature + 3 = Selects ringer tone.
Feature + 4 = Adjusts transmission/receiving volume.
Feature + 5 = Activates hands-free operation.
Feature + 6 = Deactivates hands-free operation.
Feature + 7 = Turns call indicator lamp on or off for
incoming call notification (If turned off,
this lamp will still light to indicate
message waiting.)
Feature + 8 = Selects between Normal, Dynamic Dial
Pad, and Preset Dial.
CONDITIONS FOR DT830 SERIES
Please note that following terminal settings (by Feature
Key + Digit Key) cannot be used for DT830 Series.
• Feature+0 =Side Tone On/Off (for handset)
For the settings, contact the administrator.
* You can confirm the settings in “Audio&Visual Set-
tings”  “Side Tone Volume” of Online Monitoring.
• Feature+2 =Adjusts handset receiver volume
For the settings, contact the administrator.
* You can confirm the settings in “Audio&Visual Set-
tings”  “Audio Settings”  “Receive Bias”/“Re-
ceive Gain” of Online Monitoring.
• Feature+3 =Selects ringer tone
For the settings, contact the administrator.
* You can confirm the settings in “Audio&Visual Set-
tings”  “Audio Settings”  “Ring Settings” of On-
line Monitoring.
• Feature+4 =Adjusts transmission/receiving volume
For the settings, contact the administrator.
* You can confirm the settings in “Audio&Visual Set-
tings”  “Audio Settings”  “Receive Bias”/“Re-
ceive Gain”/“Send Gain” of Online Monitoring.
• Feature+5 =Activates hands-free operation
Not Available
• Feature+6 =Deactivates hands-free operation
Not Available